Used to support DuraSpout downspout at either the offset elbow, coupler, or discharge spout. Never needs painting. Will not rust, rot or chip.
Used where fascia board does not exist or is not vertical. Tang nailed under shingles then screwed to support brackets and slip joints. Front hinge snapped over button on part No.RW105 and part No.RW106.
To support downspout at either the offset elbow coupler or discharge spout. (Estimated 70 pieces per 1000' of gutter)
Used with Repla K system or as a replacement for metal. Used where the downspout changes in any direction. Turns 112 degrees for offsets and discharge spouts.
Connects two lengths of downspout.
Used with a B-style Elbow to create an offset on side of house.
Amerimax Gutter Elbow, Front, Side, Flexible, Amerimax, 8 - 18 in Extended Length, Suitable For Use With: 2 X 3 in K-Style Downspout, 4 in and 5 in Gutters, Vinyl, White, Used to Connect Gutter or Drainpipe to Downspout
Used where fascia board does not exist or is not vertical. Attaches to roof under shingles and screwed to support brackets.
Used where the square downspout changes in any direction. Estimated 100 pieces per 1000' of gutter.
For end of gutter run.
Used with gutter fitting to make either right or left gutter stop. (Estimated 15 piece per 1000' of gutter).
Used to terminate either right or left gutter end, complete with Raingo seal. (Estimated 45 pieces per 1000' of gutter).
Basic gutter support fitting, installed every 30" of gutter length. Patented button on front for alternate use with part No. RW108. (Estimated 300 pieces per 1000' of gutter).
Used for support of gutter. Brackets can not be seen at ground level.
Amerimax Transition Elbow, Type A, 2 in Width X 3 in Depth, Suitable For Use With: 5 in K Style Gutter System, Vinyl, White
90 degree angle. Non-metallic, never needs painting. Will not rust, rot or chip. Fits anywhere downspout changes direction.