Adjust from low air to a full volume flow. Recommended air pressure to 150 PSI maximum. Knurled nozzle makes handling easy. Complete with handy pocket clip. Fits all Industrial/Milton Design 1/4" coupler bodies.

Vented nozzle to relieve the compressed air should the nozzle become plugged or accidentally obstructed. Heavy duty die cast body. Hang up hook and 1/4" NPT female inlet included. Meets OSHA regulation 1001 for 30 PSI "dead head'' pressure. Inlet Pressure - 150 PSI.

Safety blow gun.

Converts any standard ball foot tire chucks to a safety blowgun.  Vented nozzle and built-in pressure reduces limit nozzle pressure to a maximum of 30 PSI, with up to 150 PSI inlet pressure.  Conforms to No.1001 OSHA regulation. Epoxy finish.

Die-cast body. 1/4" air inlet.

Conforms to all Federal requirements related to OSHA, including noise level regulations. Tamper proof pressure reducers built into this gun limit nozzle pressure to 30 PSI or less when used with listed inlet pressure. Features vented nozzle to relieve the compressed air should the nozzle become plugged or accidentally obstructed. Heavy duty die cast, epoxy finish body. Complete with hang-up hook and 1/4" female NPT inlet.

Increased performance and yet still meets OSHA regulation 100-1 for 30 PSI 'dead head' pressure. Features vented nozzle to relieve the compressed air should the nozzle become plugged or accidentally obstructed. Heavy duty die cast body. Complete with hang-up hook and 1/4" NPT female inlet. Inlet pressure 150 PSI.

Oil resistant, soft replaceable rubber tip. Will not mar delicate surfaces. Ideal for leak proof seal against oil passages, fuel lines and carburetors when air pressure is needed for cleaning. Allows full line pressure to be used. Includes 1/4" female NPT inlet. To comply with OSHA regulations standard blowguns must be used on a regulated air line with a pressure setting not to exceed 30 PSI.

Meets OSHA regulation 100-1 for 30 PSI "dead head" pressure. Features vented nozzle to relieve the compressed air should the nozzle become plugged or accidentally obstructed. Heavy duty die cast body with hang-up hook, 1/4" NPT female inlet, and 4" extension.

Comfortable thumb lever valve control with handy hanger in lever and hanger hook. Compact one piece nozzle. Allows full line pressure to be used. Includes 1/4" female NPT inlet. To comply with OSHA regulations standard blowguns must be used on a regulated air line with a pressure setting not to exceed 30 PSI.

Interchangeable nozzles for cleaning and inflating. Complies with OSHA regulations standard blowguns must be used on a regulated air line with a pressure setting not to exceed 30 PSI. Includes: standard nozzle, tapered inflator nozzle and ball inflator nozzle.

Combination of a blowgun and the siphon spray nozzle. Barbed siphon inlet fits 1/4 inch ID hose or tubing. Use for spray- cleaning engines, applying protective coating, etc. Allows full line pressure to be used. Includes 1/4" female NPT inlet. To comply with OSHA regulations standard blowguns must be used on a regulated air line with a pressure setting not to exceed 30 PSI.

Die cast body and dial type gauge with rubber protector. Fitted with single clip-on connector. Air pressure: 0-220 PSI. Air inlet: 1/4'' NPT.