Allows you to remove the cylinder plug from all Schlage pin and tumbler keyed products without losing the top pins and springs during the re-keying process.
Designed to measure the key cuts on any Schlage key (Except SFIC) to determine what size pins should go in each chamber of the plug for re-keying purposes.
Designed to be used in the cylinder plug on all Schlage pin and tumbler keyed products that are keyed to a master key system. Designed so that two different keys will open the same lock.
Door hardware parts.
Designed to be used in the cylinder housing on all Schlage pin and tumbler keyed products. The top pins are designed to be used when master keying or construction keying. 100 pins per pack.
Designed to all you to remove the rear cap from Schlage deadbolt pin and tumbler cylinders. It allows you to unscrew the cap and depresses the pin which allows removal in one step. Each end is a different size for the appropriate deadbolt cap size.
Keying kit snap-tight plastic box. Bottom pins, top pins, pin springs, cylinder caps, cap, pins, key gauge and follower bar.
Includes bottom pins, top pins, pin springs, cylinder caps, cap springs and pins, B-series cylinder bars, key gauge, follower bar, cap removal tool and retaining rings. Packed in a seal-tight metal box.